Welcome to Advanced Polyurea & Polyaspartic Coatings

Coastal Dam Polyurea Protective Coating

Item No.: PS700B
Coastal Dam is located in severely corrosive place,it endures the erosion of the sea wave,burning sunlight and marine organism,tends to be ruined.Polyurea spray elastomer coating is an ideal protective material with good physical properties and anti-corro
PS700B is a 100% solids, two-component, fast-set, high-performance on-site spray molding materials with the development of marine oil industry,avariety of marine oil drilling platforms occurred. Drilling platforms are usually situated in remote waters, most of which are fixed on the seabed. So it’s hard to maintain as they can’t go back to shore like ships. To make the oil exploitation proceed smoothly, B compone is an isocyanate prepolymer, the A component is an MDI, a chain extender and a pigment of fire retardant, which has the advantages of high strength, good performance and quick construction .Based on the high reactivity and fast curing property, it can be sprayed forming at any bent, inclined and vertical surface without sagging. With super adhesive strength and impact resistance characteristics, the coating is flexible, impact resistant and seamless that able to completely insulate air and water and oxygen penetration. It integrated anticorrosion, waterproof, wear resistance, aging resistant performances, no pulverization and crack peel up or fall down after long- term outdoor work with alternating ambient conditions of cold, heat, rain and snow. It is the optimum choice where a tough, flexible, impact resistant, abrasion resistant waterproofing system which exhibits extraordinary performance characteristics. 
Anti-corrosion and waterproof protection of coastal and dyke dams and other facilities.
1>. Without any thinner, environmental protection;
2>. Elongation, high flexibility, can adapt to the basic cracks and slight deformation;
3>. Good aging resistance
4>. fast-set, can be sprayed on any surface, slope, vertical surface;
5>. Convenient construction, spraying a film.
Volume solid content 100%
Hardness (Shore A)   85-90
Density 1.05g/cm3
Elongation ≥420%
Tensile strength ≥30MPa
Impact strength  ≥80N/mm
Water impermeability 0.4MPa,60min
Wear resistance (750g,500r)  30mg
Impact resistance 1.5kg.m
Electric strength 15kv/mm
Temperature variation -35------+120°C
Heating temperature 55-65°C
Recommended thickness 3000μm
Operating temperature range 0-35°C
Gel time(sec) 7-15
Tack free time(sec) 30-50
Water resistance(30d) no rust no bubbles no peel
Acid resistance (10%H2SO4 or 10%HCI, 30d) no rust no bubbles no peel
Alkali resistance 10%NaOH, 30d  no rust no bubbles no peel
Salt resistance 60g/L, 30d no rust no bubbles no peel
Salt spray resistance (2000h) no rust no bubbles no peel
Oil resistance 0# diesel crude oil 30d  no rust no bubbles no peel
Material base data(25℃,60%RH)
  Main Agent Curing Agent
Appearance Colorless transparent liquid Colorless transparent liquid
Smell Slightly stimulating odor Pungent amine odor
Chemicalcomponents Polyether amine MDI
Viscosity25℃ A:450MPa 350MPaS
Proportion25℃ 1.07 0.98
Solid content 100%    98%
VOC 10 0
Two-component, A component 220KG / 200L barrel, B component 210KG / 200L barrel.
Storage/Shelf Life
Ideal storage condition is 5-35 ℃ in cool and dry place, avoid direct sunlight. / Nine months