Welcome to Advanced Polyurea & Polyaspartic Coatings

Floor Special Spray Polyurea Coating

Item No.: PS600B
It is high reactive and rapid cure and able to be sprayed forming on any bending surfaces with several minutes to reach the foot traffic.The coating film is flexible,dense tough and seamless,high adhesive strength with substrate and excellent wear and im
PS600B Floor Special Spray Polyurea coating is a 100% solids, two-component, fast-set, high-performance on-site spray molding materials. The product is mainly composed of isocyanate semi-prepolymer, terminal amino polyether chain extender and pigment., which has the advantages of high strength, good performance and quick construction .Based on the high reactivity and fast curing property, it can be sprayed forming at any bent, inclined and vertical surface without sagging. With super adhesive strength and impact resistance characteristics, the coating is flexible, impact resistant and seamless that able to completely insulate air and water and oxygen penetration. It integrated anticorrosion, waterproof, wear resistance, aging resistant performances, no pulverization and crack peel up or fall down after long- term outdoor work with alternating ambient conditions of cold, heat, rain and snow. It is the optimum choice where a tough, flexible, impact resistant, abrasion resistant waterproofing system which exhibits extraordinary performance characteristics.
 1>. FDA approved
 2>. Without any thinner, environmental protection
 3> Elasticity,silencing
 4>. Elongation, high flexibility, can adapt to the basic cracks and slight deformation
 5>. Good aging resistance
 6>. Fast-set, can be sprayed on any surface, slope, vertical surface;
 7>. Convenient construction, spraying a film.
Solids content 100%
Hardness (Shore) 85-96(A)
Density 1.05g/cm³
Elongation ≥450%
Tensile strength 18MPa
Tear strength  ≥55N/mm
Water impermeability 0.4MPa,60min
Wear resistance (750g,500r)  30mg
Impact resistance 1.5kg.m
Electric strength 15kv/mm
Temperature variation -35------+120°C
Heating temperature 55-65°C
Recommended thickness >1500μm
Operating temperature range 0-35°C
Gel time(sec) 7-15
Tack free time(sec) 30-50
Water resistance(30d) no rust no bubbles no peel
Acid resistance (10%H2SO4 or 10%HCI, 30d) no rust no bubbles no peel
Alkali resistance 10%NaOH, 30d  no rust no bubbles no peel
Salt resistance 60g/L, 30d no rust no bubbles no peel
Salt spray resistance (2000h) no rust no bubbles no peel
Oil resistance 0# diesel crude oil 30d  no rust no bubbles no peel
Workshop floor engineering for petrochemical, food processing, pharmaceutical, electronics and other industries, stadiums, parking lots, supermarkets and other floor projects.
Two-component, A component 220KG / 200L barrel, B component 210KG / 200L barrel.
torage/Shelf Life
Ideal storage condition is 5-35 ℃ in cool and dry place, avoid direct sunlight. / Nine months