Welcome to Advanced Polyurea & Polyaspartic Coatings

Pure Polyurea Coatings

Item No.: PS500A-Pure
This pure polyurea system is a very fast-set, 2-component, 100% solids, No VOCs, flexible coating. Spray-applied elastomers provide significant protection to various metal/steel, wood, concrete, urethane foam, and many other substrates.
Pure Polyurea Coating PS500A is a 100% solid, fast curing, two component, and aromatic,100% Pure polyurea coating system derived from a reaction of an isocyanate prepolymer, MDI, a chain extender, and a pigment, which has the advantages of high strength, good performance and quick construction.Based on the high reactivity and fast curing property, it can be sprayed forming at any bent, inclined and vertical surface without sagging. With super adhesive strength and impact-resistant characteristics, the coating is flexible, impact-resistant, and seamless and is able to completely insulate air, water, and oxygen penetration. It integrated anticorrosion, waterproof, wear resistance, aging resistant performances, no pulverization and crack peel up or fall down after long- term outdoor work with alternating ambient conditions of cold, heat, rain and snow. It is the optimum choice where a tough, flexible, impact resistant, abrasion resistant waterproofing system which exhibits extraordinary performance characteristics.
  • 100% solid, VOC free, no solvents, environmental protection
  • Seamless coating
  • Fast curing, can be sprayed on any surface, slope, vertical surface
  • Elongation, high flexibility, can adapt to the basic cracks and slight deformation
  • Excellent tensile and structural strength
  • Good aging resistance
  • Excellent thermal stability
  • Excellent impact and abrasion resistance
  • Excellent chemical resistance
  • Excellent flexibility
  • Excellent crack-bridging properties
  • Convenient construction, spraying a film
Solid content 100%
Hardness (Shore A) 85-96
Density 1.05gr/cm3
Elongation at break ≥450%
Tensile strength 19MPa
Tear strength  ≥60N/mm
Water impermeability 0.4MPa,60min
Wear resistance (750g,500r)  30mg
Impact resistance 1.5kg.m
Electric strength 15kv/mm
Temperature variation -35---+120°C
Heating temperature 55-65°C
Recommended thickness >1500μm
Operating temperature range 0-35°C
Gel time(sec) 7-15
Tack free time(sec) 30-50
Water resistance(30d) no rust no bubbles no peel
Acid resistance (10%H2SO4 or 10%HCI, 30d) no rust no bubbles no peel
Alkali resistance 10%NaOH, 30d  no rust no bubbles no peel
Salt resistance 60g/L, 30d no rust no bubbles no peel
Salt spray resistance (2000h) no rust no bubbles no peel
Oil resistance 0# diesel crude oil 30d  no rust no bubbles no peel
  • Metal, concrete, wood, and foam roofing
  • Industrial floors
  • Hospitals, factory, parking lots  and garages
  • Water & wastewater linings
  • Pools, swimming pools
  • Water tanks and pipes
  • Truck bed and undercarriage liner
  • Roads , bridge decks, railways and high  speed  railways
  • High abrasion applications
  • Oil and gas industry,Marine industry
  • Water parks, aquariums linings  and play grounds
  • Joint fill and sealant
Two-component, A component 220KG / 200L barrel, B component 210KG / 200L barrel.
Storage/Shelf Life
Ideal storage condition is 5-35 ℃ in cool and dry place, avoid direct sunlight. / Nine months