Welcome to Advanced Polyurea & Polyaspartic Coatings
icon

Solvent-free drinking water tank coating

Item No.: 725-H45-66
- A two pack drinking water tank epoxy coatings.
- Approved by Ministry of Health of the state for use in contace
  with potable water.
- VOC less than 50g/L.
Description
Intended Uses
- For use in drinking water tank.
- For use at Newbuilding, Maintenance and Repair or On Board Maintenance.
Product Information
Volume Solids:100%                  Finish/Sheen:  Gloss
Typical Film Thickness 300microns dry (300microns wet)
Theoretical Coverage(m2/L) 3.3m2/L at typical film thickness
Mix Ratio: 3.4:1(volume)5:1(mass)
Method of Application  
Airless Spray Recommended
Tip size range:0.38-0.53mm
Output pressure:≥17MPa
Air Spray Not recommended
Brush/Roller For small area only
Thinner Not recommended.
Cleaner HX-501
Induction Period Not necessary
Drying Information
          10℃                25℃              35℃        
Touch Dry   4h 2h 1h
Hard Dry 48h 20h 14h
Pot Life 2h 1h 0.5h
Overcoating Data
Substrate Temperature  10℃ 25℃ 35℃
Overcoated by Min Max Min Max Min Max
725-H45-66 48h  4d 20h 3d 14h 1.5d
Storage
Store in cool and dry conditions,Well ventilate.Keep away from hot and fire. Shelf Life: 12 months
minimum at 25 ℃,Subject to re-inspection thereafter.
Pack Size
Part A: 25kg/15.5L in 20L container
Part B: 5kg/4.5L in 6L container
Flash Point
Part A: Greater than 50℃
Part B: Greater than 50℃
Mixed pant: Greater than 50℃
Systems and Compatibility
Consult your sales Representative for the systems best suited for the surfaces to be protected.